How to build FET Audio Mixer



This simple circuit mixes two or more channels into one channel (eg. stereo into mono). The circuit can mix as many or as few channels as you like and consumes very little power. The mixer is shown with two inputs, but you can add as many as you want by just duplicating the "sections" which are clearly visible on the schematic.

Circuit diagram

Parts
R1, R3 10K Pot
R2, R4 100K 1/4 W Resistor
R5 6.8K 1/4 W Resistor
C1, C2, C3 0.1uF Capacitor
Q1 2N3819 Junction FET
MISC Wire, Shielded (Metal) Case, Phono Or Other Plug For Output

Notes
1. As many or as few channels as are required can be added to the mixer. Do this by just duplicating the input "sections" which are clearly shown on the schematic. One version of this mixer I saw had 25 inputs!
2. A shielded case is probably needed to reduce hum and help stop oscillations.
3. The circuit can be powered by a single 9 volt battery.


Author:
Email:
Website: http://www.aaroncake.net

Similar diagrams


Important!!!
We are not responsible for any injuries or damage caused by information from this website! Working with electricity is dangerous for your life, especially diagrams related to high voltage! We do not guarantee success in building devices using our diagrams! They are not tested by us. For questions about diagrams use author info below diagram or our contact page. Thank you!