How to build Headlight Flasher

this circuit diagram belongs to Automotive category.




Circuit diagram

+September 98 Project : Headlight FlasherThis circuit was requested from an email. It will allow your car headlights to flash on and off at the same time or it will cause them to flash alternately. The circuit is based on the 555 timer. It is used in the astable mode. The 555 timer output will go high for an adjustable period of time and then turn off. It will then repeat the procedure.
The time is adjusted by R1. To hook up the circuit to your car you must locate the positive wire from the fuse box to the headlights. Cut the wire and insert the relay contact and bypass switch. The bypass switch will allow you to bypass the relay contact for normal headlight operation. In the alternateing headlight configuration you must cut the positive wire to each headlight and wire in the relay contact.

Author:
Email:
Website: http://www.electronics-lab.com

Similar diagrams

Nite Rider Lights circuit diagram
Nite Rider Lights
Pulsing Third Brake Light circuit diagram
Pulsing Third Brake Light
Headlight Flasher circuit diagram
Headlight Flasher
Headlights Timer circuit diagram
Headlights Timer
Automatic Headlight Brightness Switch circuit diagram
Automatic Headlight Brightness Switch
Important!!!
We are not responsible for any injuries or damage caused by information from this website! Working with electricity is dangerous for your life, especially diagrams related to high voltage! We do not guarantee success in building devices using our diagrams! They are not tested by us. For questions about diagrams use author info below diagram or our contact page. Thank you!