•  Audio
•  Power
•  Radio
•  Light, LED
•  Tools
•  Telephone
•  Automotive
•  MCU
•  Control
•  Timers
•  Misc

How to build 2N3055 Power Amplifier

Simple and low cost. The optimal supply voltage is around 50V, but this amp work from 30 to 60V. The maximal input voltage is around 0.8 - 1V. As you can see, in this design the components have a big tolerance, so you can build it almost of the components, which you find at home. The and transistors can be any NPN type power transistor, but do not use Darlington types... The output power is around 60W.

Some comments:
- capacitor C1 regulates the low frequencies (bass), as the capacitance grows, the low frequncies are getting louder.
- capacitor C2 regulates the higher frequencies (treble), as the capacitance grows, the higher frequencies are getting quiter.
- this is a class B amplifier, this means, that a current must flow through the end transistors, even if there is no signal on the input. This current can be regulated with the 500ohm; trimmer resistor. As this current incrases, the sound of the amplifier gets better, but the end transistors are more heating. But if this current decrases, the transistors are not heating so much, but the sound gets worse...

Circuit diagram

Similar diagrams

Amplifier 2x30W with STK465

2N3055 Power Amplifier

5,000W ultra-light, high-power amplifier, without switching-mode power supply

100W RMS Amplifier

200W audio amplifier

60W Bass Amplifier

60W Guitar Amplifier

50 Watt Amplifier